- With container upright, remove upper half of the container box.
- Remove foam layer I, which is a plain layer.
- Remove 3 transfer lines, 2 pump fittings, 1 fitting adaptor,
and 1 gear cover from the foam layer II.
- Remove foam layer II.
Install gear cover to the handling fixture to cover the worm gear.
- Attach the cable slings to loading fixture, two places, adjust the sling
length equally. (= white position) Draw the pin, which is located near the
middle of the installing fixture, out from the attachment block and insert
it to the top of the installing fixture.
- With care, slowly lift up the installing fixture. Unhook the fixture
from the dewar.
- Remove the window cover from the foam.
- Remove foam layer III, which consists of two pieces.
- Remove LHe level sensor and thermometer.
- Lower the installation fixture to the camera top. Hook up to the
attachment blocks, and push the pin back to its original position.
- Adjust the cable slings towards the dewar bottom (= green position).
Lift the camera slightly to ensure the camera is level. If it is not
level, lower the camera and readjust to level. Lift camera up.
- Remove foam layer IV, which also consists of two pieces.
- Remove foam layer V.
- Remove gear cover, pull 2 pins out from handling fixture.
- Lower the camera onto the handling fixture, ensuring that the
gears match properly. Push pins back to original position. Reinstall
the gear cover.
- Lift the camera with the handling fixture up. The unloading
procedure is completed.
|
|